Dranetz Visa Uživatelská příručka Strana 219
- Strana / 274
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
C-3
APPENDIX C/ Battery Specifications and Replacement Procedure
Battery Pack Safety Precautions
WARNING
DO NOT intentionally short circuit the battery pack. The batteries are capable of
providing hazardous output currents if short circuited. The PowerVisa is
equipped with an internal battery charger circuit. Do not attempt to charge the
batteries with an external charger other than the Dranetz-BMI battery charger,
since improper charging could cause battery explosion.
ADVERTENCIA
NO ponga intencionalmente la baterÌa en cortocircuito. Las baterÌas son capaces
de proporcionar corrientes de salida peligrosas si est·n en cortocircuito. La
PowerVisa est· equipada con un circuito interno cargador de baterÌas. No intente
cargar las baterÌas con un cargador externo que no sea el cargador de baterÌas
Dranetz-BMI, puesto que la carga indebida podrÌa hacer que explote la baterÌa.
AVERTISSEMENT
NE PAS court-circuiter délibérément le bloc-batterie. Lors díun court-circuit, les
batteries risquent díémettre des courants effectifs dangereux. PowerVisa posséde
un circuit de chargeur de batterie intégré. Ne pas tenter de charger les batteries
au moyen díun chargeur externe autre que le chargeur de batterie Dranetz-BMI,
car un rechargement fautif pourrait entraÓner líexplosion de la batterie.
WARNUNG
Die Batterien dürfen NICHT kurzgeschlossen werden. Im Falle eines
Kurzschlusses kˆnnen die Batterien lebensgefährliche Ausgangsstrˆme leiten.
PowerVisa ist mit einem internen Batterieladegerät ausgestattet. Die Batterien
sollten nur mit dem Ladegerät von Dranetz-BMI geladen werden. Die
Verwendung eines externen Ladegeräts kann zu einer Explosion der Batterien
führen.
Battery safety
precautions
Observe the following precautions when inspecting or replacing the battery pack:
• Do not attempt to replace individual batteries of the pack or substitute other battery
types.
• Do not dispose of battery in fire.
• Dispose of a used battery promptly in accordance with local Environmental
Protection Agency (EPA) regulations.
• Visually inspect the battery pack for corrosion.
The batteries have a safety pressure vent to prevent excessive gas build-up and
corrosion indicates that venting has occurred. Possible causes of venting are: a
defective charger, excessive temperature, excessive discharge rate, or a defective
cell.
If corrosion is excessive, the battery pack may require replacement (contact Dranetz-
BMI Customer Service Department).
- PowerVisa 1
- ADVERTENCIA 3
- WARNUNG 3
- Safety Summary 4
- Safety Summary, Continued 5
- Statements and Notices 7
- Continued 8
- Table of Contents 9
- Table of Contents, Continued 10
- Dranetz-BMI PowerVisa 13
- CHAPTER 1 15
- Getting Started 15
- Unpacking the PowerVisa 17
- Standard Accessories 18
- Top View 19
- Front View 19
- Rear View 19
- Bottom View 19
- 1 2 3 5 6 7 8 9 10 11 124 20
- CH 1/ Getting Started 21
- 2 3 5 64 22
- Rear view 23
- PowerVisa firmware 24
- PowerVisa Features 26
- Basic Operation 28
- PVISA001 29
- Basic Operation, continued 30
- CHAPTER 2 31
- PX5-11.vsd 35
- PX5-12.vsd 36
- PX5-13.vsd 37
- Connecting Current Probes 39
- 4300 TO LEMFLEX 40
- CURRENT PROBE 40
- ADAPTER CABLE 40
- 116310-G1 40
- PX5-14.vsd 40
- PX5-15.vsd 42
- CHAPTER 3 43
- View Real Time Data 43
- Turning Channels On/Off 45
- Checking Input Range 46
- Standard Meter Tab 48
- CH 3/ View Real Time Data 49
- Distortion Meter Tab 50
- Harmonic Graph 53
- Harmonic Detail 54
- Harmonic Options 55
- Harmonic Options, continued 56
- Harmonic List 57
- Phasor Screen 59
- Phasor Rotation 60
- CHAPTER 4 63
- Time and Date Settings 65
- Select Language 67
- Set Display Preferences 68
- Touch Screen Calibration 69
- Turn Threshold Beeper On/Off 71
- Data Card 74
- CH 4/ Instrument Settings 77
- CHAPTER 5 79
- Start Menu 79
- Current Probe Selection 86
- Scale Factor Setup 88
- Circuit Type Selection 90
- Nominal Values 92
- Nominal Values, continued 94
- Mode of Operation 95
- Monitoring Mode 96
- Advanced Options 97
- Site Name/Memory Card 98
- Action... Result 100
- CH 5/ Start Menu 101
- Section C 102
- Turning Monitoring On/Off 103
- Section D 112
- Section E 113
- Overview 113
- Card Error Messages 114
- CHAPTER 6 115
- Advanced Setup Options 115
- Advanced Options Menu 116
- Transient Limit 117
- RMS Variation Limit 122
- Waveform Capture 127
- Characterizer Options 128
- Journal Limit 129
- CH 6/ Advanced Setup Options 131
- 1 SEC, 1 MIN, 2 MINS 133
- 3 MINS, 5 MINS, 10 MINS 133
- 15 MINS, 1 HR 133
- 10%); Medium Voltage (11 135
- CHAPTER 7 137
- View Event Data 137
- Overview, continued 138
- Section A 140
- Event Data Display 141
- Event Activity Graph 142
- Event List 143
- Event Detail 145
- Event Options 150
- Section B 153
- Trend Display 154
- Trend Setup 155
- • Press OK to accept changes 156
- CH 7/ View Event Data 157
- CHAPTER 8 159
- Continued on next page 161
- EN50160 Compliance Limits 163
- CH 8/ Reports 165
- Compliance History 169
- Compliance History, continued 170
- Event Satistics 171
- Event Statistics, continued 172
- Panel Setup Options 175
- Panel Operation 177
- CHAPTER 9 181
- Downloading Events 181
- Communications 182
- CH 9/ Downloading Events 183
- Viewing Events via DranView 191
- DranView 192
- with HASP 192
- Top Side Bottom Side 193
- with HASP, continued 194
- APPENDIX A 195
- Optional Accessories 195
- Software Accessories List 202
- APPENDIX B 205
- Technical Specifications 205
- Interfaces 207
- Measured Parameters 208
- Computed Parameters 209
- WATTWATTWATTWATT ++= 211
- 61000-4-30 214
- TR2500 Current Probe 215
- TR2510 Current Probe 216
- APPENDIX C 217
- Battery Specifications 218
- AVERTISSEMENT 219
- Battery Pack Replacement 220
- Battery removal 221
- APPENDIX D 223
- User Replaceable Parts List 223
- APPENDIX E 225
- Common Circuit Connections 225
- Single Phase 231
- Split Phase 232
- 3 Phase, Four Wire Wye 233
- 3 Phase 2-Watt Delta 235
- Generic Circuit 236
- APPENDIX F 245
- Event Classification 245
- Variations as per 247
- IEEE, IEC, and 247
- Dranetz-BMI 247
- (continued) 247
- Range of 247
- APPENDIX G 249
- PowerVisa Menu Structure 249
- LEVEL 100/1 251
- Start Menu - Automatic Setup 251
- To Level 001 251
- To Level 108 252
- To Level 112 253
- LEVEL 100/2(b) 253
- Start Menu - Wizard Setup 253
- LEVEL 100/3a 254
- TO LEVEL 100/3b 254
- LEVEL 100/3b 255
- LEVEL 100/4 256
- LEVEL 100/5 256
- LEVEL 150 257
- Instrument Settings 257
- See Level 100/1 258
- To Level 200 258
- To Level 240 258
- LEVEL 200 259
- Scope Mode 259
- LEVEL 300/1 260
- Meter Mode - Standard 260
- LEVEL 300/2 261
- Meter Mode - Distortion 261
- 261
- LEVEL 240 263
- Phasor Display 263
- LEVEL 112_101 264
- Advanced Options 264
- LEVEL 112_201 265
- MARK112_207 266
- MARK112_208 266
- MARK112_214 266
- LEVEL 112_501 267
- Level 112_601 268
- Journal Interval 268
- LEVEL 112_701 269
- EN50160 Options 269
- Home screen 273
- LEVEL 470(b) 274
- Reports – PQ Status 274
Související produkty a manuály pro Měření, testování a kontrola Dranetz Visa
(77 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.019 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce