Dranetz Guide Specifikace stáhnout pdf (Strana 34)

 Set RMS Diff Transients – use to set the rms distortion

waveshape limit. The rms deviation algorithm subtracts the same

point-on-wave sample values from previous to present cycle then

calculates the rms value of the deviation over an entire cycle. If

this value exceeds the threshold, then a trigger occurs.

 Set High Frequency Transients – the high speed sampling

analog board installed in Dranetz HDPQ Xplorer enables it to

detect and capture transients as small as 1 microsecond in

duration. This transient detection algorithm is only available on

the Xplorer.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Žádné komentáře

Dranetz Guide Specifikace Strana 34